3DPrinting/config1

From Interlock Rochester Wiki
Jump to: navigation, search

From http://dl.dropbox.com/u/432694/huxley_20120325_BMB.ini

acceleration = 0
bed_temperature = 0
bottom_layer_speed_ratio = 0.3
bridge_fan_speed = 100
bridge_flow_ratio = 1
bridge_speed = 60
cooling = 0
disable_fan_first_layers = 1
duplicate_distance = 6
duplicate_x = 1
duplicate_y = 1
end_gcode = M104 S0 ; turn off hot end\nM140 S0 ; turn off bed\nG0 X0 Y144 ; present the print\nM84     ; disable motors
extrusion_axis = E
extrusion_multiplier = .99
extrusion_width_ratio = 0
fan_always_on = 0
fan_below_layer_time = 60
filament_diameter = 1.75
fill_angle = 45
fill_density = 0.25
fill_pattern = rectilinear
first_layer_bed_temperature = 0
first_layer_height_ratio = 1
first_layer_temperature = 200
g0 = 0
gcode_arcs = 0
gcode_comments = 0
gcode_flavor = reprap
infill_acceleration = 50
infill_every_layers = 1
infill_speed = 80
layer_height = 0.3
max_fan_speed = 100
min_fan_speed = 35
min_print_speed = 10
notes = 
nozzle_diameter = 0.5
output_filename_format = [input_filename_base].g
perimeter_acceleration = 25
perimeter_speed = 30
perimeters = 3
post_process = 
print_center = 72,72
retract_before_travel = 2
retract_length = 3
retract_lift = 0
retract_restart_extra = 0
retract_speed = 30
rotate = 0
scale = 1
skirt_distance = 6
skirt_height = 1
skirts = 1
slowdown_below_layer_time = 15
small_perimeter_speed = 30
solid_fill_pattern = rectilinear
solid_infill_speed = 60
solid_layers = 3
start_gcode = G28 ; home all axes
support_material = 0
support_material_tool = 0
temperature = 180
travel_speed = 150
use_relative_e_distances = 1
z_offset = 0